Duplex - Motorola RFS7000 Series Reference Manual

7.1.3 duplex

Interface Config commands
Use this command to configure a duplex type for the interface.
NOTE
• Duplexity can only be set for an Ethernet type interface. Enter the
instance using an
• Duplex cannot be set until the speed is set to a non-auto value.
Syntax
duplex(auto|full|half)
Parameters
auto
full
half
Usage Guidelines
Duplex defines the type of communication used by the port. The switch, by default, is set as
auto mode the duplex is selected based on the connected network hardware.
Example
RFS7000(config)#interface ge4
RFS7000(config-if)#duplex ?
auto set auto-negotiate
full set full-duplex
half set half-duplex
RFS7000(config-if)#duplex full
RFS7000(config-if)#
parameter in an
ge/me
Sets the auto-negotiate parameter.
Sets full-duplex where data can be passed in both direction simultaneoulsy.
Sets half-duplex where data can only be passed in one direction at a time.
(config-if)
mode.
interface
7-5
duplex. In
auto