Disassembly Instructions; Removal Of Mechanical Parts And P.c. Boards - Toshiba SD-3860SCA Service Manual

1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1: TOP CABINET/FRONT CABINET (Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2. Remove the Top Cabinet in the direction of arrow (A).
Unlock the 4 supports 2.
3.
4. Remove the Front Cabinet in the direction of arrow (B).
1
Front Cabinet
2
(B)
2
2
1-2: POWER PCB (Refer to Fig. 1-2)
1. Disconnect the following connectors: (CP4001, CP4002).
Remove the 3 screws 1.
2.
3. Remove the Power PCB in the direction of arrow.
1

DISASSEMBLY INSTRUCTIONS

Top Cabinet
1
1
(A)
1
2
Fig. 1-1
1
1
Power PCB
Fig. 1-2
1-3: DVD DECK (Refer to Fig. 1-3)
1. Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
2. Disconnect the following connectors:
(CP2601, CP2602, CP2603).
Remove the 4 screws 1.
3.
4. Remove the DVD Deck in the direction of arrow.
DVD Deck
1
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
1-4: DVD PCB (Refer to Fig. 1-4)
Remove the 4 screws 1.
1.
Remove the 3 screws 2.
2.
3. Remove the DVD PCB in the direction of arrow.
B1-1
1
1
1
1
Make the short circuit
using a soldering.
2
DVD PCB
2
1 1
1
1
Pick Up PCB
Fig. 1-3
2
Fig. 1-4