Disassembly Instructions; Removal Of Mechanical Parts And P.c. Boards - Toshiba SD-V320SCA Service Manual

1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1: TOP CABINET, FRONT CABINET, OPERATION 1/2
PCB AND FRONT JACK PCB (Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2. Remove the Top Cabinet in the direction of arrow (A).
3. Disconnect the following connectors:
(CP651 and CP652).
Unlock the 8 supports 2.
4.
5. Remove the Front Cabinet in the direction of arrow (B).
Remove the 11 screws 3.
6.
7. Remove the Operation 1/2 PCB and Front Jack PCB in
the direction of arrow (C).
8. Remove the 3 Pin Shield.
Operation 1 PCB
3
3
3
3
Front Jack PCB
3
3
3 Pin Shield
2
2
(B)
2
2
(C)
2
2
2
2
Front Cabinet
1-2: FLAP (Refer to Fig. 1-2)
1. Open Flap to 90˚ and flex in direction of arrow (A), at the
same time slide in direction of arrow (B).
2. Then lift in direction of arrow (C).
(C)

DISASSEMBLY INSTRUCTIONS

Top Cabinet
1
1
1
(A)
1
3
3 3
3
3
Operation 2 PCB
Fig. 1-1
(A)
(B)
Flap
Fig. 1-2
1-3: DVD DECK/DVD PCB (Refer to Fig. 1-3)
1. Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Unlock the support 1 and remove the Deck Top Holder
2.
in the direction of arrow (A).
Remove the 2 screws 2.
3.
Remove the 2 screws 3.
4.
5. Disconnect the following connectors:
(CP501, CP8001).
6. Remove the DVD Deck in the direction of arrow (B).
Remove the 2 screws 4.
7.
8. Disconnect the following connectors:
(CP2601, CP2602, CP2603).
9. Remove the DVD PCB in the direction of arrow (C).
Remove the 3 screws 5.
10.
11. Remove the Front Angle in the direction of arrow (D).
1
5
5
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and VCR PCB connector.
B1-1
4
4
DVD Deck
3
Deck Top Holder
2
(C)
1
2
(A)
(B)
5
(D)
Front Angle
DVD PCB
Pick Up PCB
3
Make the sort circuit
using a soldering.
Fig. 1-3