Yale ENA-DC SmartHome Alarm series User Manual

Wirefree magnetic door/window contact

Download this manual

SmartHome Alarm series

Wirefree Yale ENA-DC

Magnetic Door/Window

contact

Features:

1. Learn / Test Button

-Press the Test button once to enter Test

Mode for 3 minutes.

-Press & hold the Test button for 8 seconds

to enable Tilt Switch function.

2. LED Indicator

3. Tilt Switch

4. Supervision Enable / Disable Jumper

5. Battery

6. Battery Insulator

7. Top & Bottom Cover securing screw hole

8. Knockouts

9. Rib Mark (for aligning magnet)

Pack contents:

1 x Door contact

1 x Magnet

2 x Magnet spacer

4 x Screws

4 x Wall plug

2 x Adhesive stickers

1 x ½ AA lithium battery

Supervision Enable/Disable Jumper

After installation, the DC will automatically transmit

Supervisory signals periodically to the Control Panel

at random intervals of less than 20 minutes. If the

Control Panel has not received the signal from the

DC for the preset period of time, the Control Panel

will indicate on its display that the particular DC is

experiencing an out-of-signal problem.

Jumper On= Supervision Disabled

Jumper Off= Supervision Enabled (Default)

Page 1 SmartHome Alarm series Wirefree Yale ENA-DC Magnetic Door/Window contact Features: 1. Learn / Test Button Supervision Enable/Disable Jumper -Press the Test button once to enter Test After installation, the DC will automatically transmit Mode for 3 minutes. Supervisory signals periodically to the Control Panel -Press &...
Page 2 • The magnet should not be more than 20mm Programming from the detector when the door is closed. Step 1: Pull out the Door contact battery tab. Magnet Step 2: Login to the engineer menu on the control panel. Select “Zone Settings” → “Zone Config. ” → “Add Zone” on the menu. Press OK and the LCD of the Control Panel will display “*Push button on* Device to add”.
Page 3 Operation Specification LED indicator Environmental conditions: -10c to 40c , relative humidity 85% non- Normal operation condensing. Indoor use only LED flash - Detects motion during Low (2 sec) battery, Tamper activated or Test Radio mode. 868.35MHz FM - Tilt tamper switch is activated. Battery: 1x 3.6V 1/2AA Lithium battery Tilt Switches...
Page 4 • Has not been modified or damaged in any way. • Has not been subjected to unauthorized repairs. Yale are responsible under this guarantee for repairing the product or replacing the product as we deem necessary. If there is fault with the product, please contact Customer Services on 01902 364647,...