Yale ENA-PIR Instruction Manual

Wirefree passive infrared motion detector, smarthome alarm series

Download this manual

SmartHome Alarm series

Wirefree Yale ENA-PIR

Passive infrared motion

detector

Features:

1. Test/Learn Button

To enter Test mode: Press once in Standby mode.

The LED will light up for two seconds whenever a

movement is detected.

2. Red LED Indicator

3. Knockouts for Wall / Corner Mounting

4. Supervision Enable / Disable Jumper

5. Movement High/Low Sensitivity jumper

6. Tamper Switch with spring

7. 3x 1.5V AA Alkaline Battery

8. Tilt Switch

(protect against unauthorized EIR

removal, sabotage, or loose installation)

9. Top & Bottom Cover securing screw hole

Pack content:

1 x PIR

4 x Screws

4 x Wall Plugs

Supervision Enable/Disable Jumper

After installation, the PIR will automatically transmit

Supervisory signals periodically to the Control Panel

at random intervals of less than 20 minutes. If the

Control Panel has not received the signal from the

PIR for the preset period of time, the Control Panel

will indicate on its display that the particular PIR is

experiencing an out-of-signal problem.

Jumper On= Supervision Disabled

Jumper Off= Supervision Enabled (Default)

Movement High/Low Sensitivity Jumper

Jumper On= Increase PIR sensitivity to movement

Jumper Off= Decrease sensitivity (Factory Default)

Page 1 SmartHome Alarm series Wirefree Yale ENA-PIR Passive infrared motion detector Features: Supervision Enable/Disable Jumper After installation, the PIR will automatically transmit 1. Test/Learn Button Supervisory signals periodically to the Control Panel To enter Test mode: Press once in Standby mode.
Page 2 view. Programming • Between 1.9 ~ 2.0 M above ground for best performance. Step 1: Remove the PIR battery insulator • In a corner to give the widest view. on the back. It will take 30 seconds for the • Where its field of view will not be obstructed PIR to initalise (with LED flashing). To allow e.g. by curtains, ornaments etc. calibration, stay away from the detection lens during this period.
Page 3 Operation Test Mode Press Test button/LED once to enter test mode. Under test mode, the sleep timer is disabled Sleep Timer and the LED lights up whenever movement is detected. The device will auto exit test mode after The PIR features an automatic “sleep time” of 3 minutes.
Page 4 United Kingdom only. This guarantee does not apply to normal wear and tear. This does not affect your statutory rights. A full copy of the product instructions are available upon request or by visiting our website www.yale. co.uk. RoHS...