Page 1
Mini Door/Window Contact Manual AC-MDC The Mini Door/Window Contact monitors the opening/closing of specified doors and windows and is fixed to the monitored device frame with a magnet fixed to the device. When the door or window opens, the magnet moves away from the Mini Door/Window Contact, activating an internal magnetic switch causing it to transmit an alarm signal to the Sync Hub.
Mini Door Contact (MDC-3) User Manual The Mini Door Contact monitors the opening/closing of specified devices (e.g. door or window). The Door Contact is fixed to the monitored device frame with an actuating magnet fixed to the device. When the door or window opens, the magnet moves away from the Door Contact, activating an internal magnetic switch causing the Door Contact to transmit alarm signal to the Control Panel.
1 x Double-Sided Adhesive Tape Pad (for Magnet) g) 2 x Magnet Mounting Screws Features LED Indicator In Normal Operation Mode, the LED indicator remains off except in the following situations: • When Mini Door/Window Contact’s Tamper switch is triggered. •...
Changing Battery ou need to open the cover to insert/remove the battery: Step 1. Use a flat-headed screwdriver to fit into the cover opening hole on one side as. Step 2. Push the flat-headed screwdriver upwards as. Step 3. Turn to the other side and repeat Step 1 and Step 2. Step 4.
Test Mode • The Mini Door/Window Contact can be put into Test mode for 3 minutes by pressing the Test Button once. • Under Test Mode, the LED will light up whenever the Mini Door/ Window Contact is activated. • Each additional Test Button press will reset Test Mode time to 3 minutes.
Step 5: After the Mini Door/Window Contact is learnt-in, put the Control Panel into “Walk Test” mode, hold the Mini Door/Window Contact at the desired location, and press the Test button to confirm if this location is within signal range of the Control Panel. Step 6: When you are satisfied with the Mini Door/Window Contact at the chosen location, proceed to installation.
Page 7
To Mount the Mini Door/Window Contact: Remove the cover. II. Break through the knockout on the back cover. III. Using the holes as a template, drill both holes. IV. Insert wall plugs if fixing into plaster or brick. V. Screw the back cover into the wall plug using a Philips screwdriver. VI.
Mounting Methods for the Magnet Screw Mounting The back cover of the magnet has two Mounting Holes for mounting purpose. To Mount the Magnet: I. Open the back cover by using a flat-headed screwdriver to fit into the caved in area and push upwards. II.
Page 9
II. Remove the protective covering from one side of the double-sided adhesive pad or the double-sided adhesive Magnet Spacer. Apply to the back of the Magnet and press firmly for 30 seconds to ensure good contact. III. Remove the other cover and firmly press the Magnet onto the desired location for 30 seconds.
Page 10
www.yalehome.co.uk Security & Risk Communications Limited, Parkway Trusted Business Centre, Ballymount, Dublin, Ireland, 24 every day ASSA ABLOY Opening Solutions UK & Ireland School Street, Willenhall West Midlands, WV13 3PW UK Version 1A...