Connecting Speakers (4 Stereo Zones) - Denon HEOS Drive Owner's Manual

Contents

Connecting Speakers (4 Stereo Zones)

o Connecting Speakers
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
2
Turn the speaker terminal counterclockwise to loosen
it.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Setup Use Troubleshooting
NOTE
0 Turn off the power switch of rear panel before connecting the speakers. Also, turn
off any connected powered subwoofers.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other.
0 Never touch the speaker terminals while the power cord is connected and power
switch of rear panel is turned on. Doing so could result in electric shock.
0 Use speakers with an impedance of 4 – 16 Ω/ohms. The protection circuit may be
activated if speakers with an impedance other than specified are used.
(R) (L)
q w q
14
Status LED Appendix
w