Breville BDC650 the Grind Control Instruction Book page 16

TROUBLESHOOTING TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
Amount brewed There is excessive
is too little / too mineral build-up affecting
much the performance of the
machine.
The volume calibrations
need to be reset.
The water tank was filled
once the coffee machine
had already started a
brewing cycle.
The programmed brew
size are approximate
only. Actual amounts
may vary due to the type
of filter used, the coffee
bean size, roast, blend and
freshness, or amount and
type of pre-ground coffee
used. These factors affect
the amount of water
retained by the coffee
grounds.
'DE-SCALE' on There is excessive
LCD screen mineral build-up affecting
the performance of the
machine.
I want to empty the
water tank
30
WHAT TO DO
De-scale the machine. Refer to
'Removing Calcium Build-Up',
page 25.
Recalibrate the machine by
flushing it twice. Refer to 'Using
the Grind Control™ - Carafe Mode.
First Time Use Only', page 12.
Always fill the water tank before
starting a brewing cycle.
Remove the 'DE-SCALE' icon
by press and hold the Strength
button for 5 seconds, then de-scale
the machine. Refer to 'Removing
Calcium Build-Up', page 25.
• Select water amount indicated
on the LCD
• Select Pre-ground setting
• Ensure the Carafe is in place
• Press Start/Cancel
• Discard the water when finished
TROUBLESHOOTING TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
Water is leaking Water tank is overfilled.
from the back of
the machine
Brewing cycle If using the gold tone
finishes before filter, this is normal.
the ready signal The total brewing time
displayed on the LCD
screen is calculated using
paper filters as coffee
passes through paper
filters slower.
Steam when This is normal.
grinding and It is the rear steam vent
brewing releasing steam.
Total brewing The total brewing time
time on LCD displayed at the start of
screen changes the cycle is an estimate
mid-cycle or is only and may change
different each time mid-cycle or vary each
time depending on the
starting temperature
of the water in the
water tank.
'CLEAN COFFEE Grinding burrs and coffee
CHUTE' on LCD grinds chute need to be
screen cleaned. We recommend
doing this immediately
to avoid clogging and
overflowing of the coffee
basket.
WHAT TO DO
Do not exceed the 12 cup maximum.
The machine will beep when full
and the water level float will rise to
indicate the maximum level.
• Thoroughly clean the coffee
basket and gold tone filter
to ensure they are clear and
unclogged of any coffee grinds.
• Check the bean hopper for any
foreign body.
• Refer to 'Cleaning the Grinding
Burrs and Coffee Grinds Chute',
page 23.
31