Working Instruction, Mechanical
2.1.3 Upper Front Assembly Complete
Remove the two inside screws from the upper carrier
assembly by using the NTZ 112 288 (torx bit no 6).
Replace the screw if it's damaged otherwise it can be
reused.
Use the front opening tool to bend and make the upper front
assembly complete to start to become loose.
B
!
E CAREFUL NOT TO BREAK THE FRONT
Continue to bend further down on the upper front assembly
complete until it's loose on this side.
Start on the opposite side and do the same thing.
3/000 21-1/FEA 209 544/104 C
9(87)
©
Sony Ericsson Mobile Communications AB