Adjusting The Height Of The Knee Lifter; Installing The Thread Stand - JUKI DDL-8100e Instruction Manual

4. aDJustInG tHE HEIGHt oF tHE KnEE LIFtEr

WarnInG :
to avoid possible personal injury due to abrupt start of the machine, turn off the power to the
machine and check to be sure that the motor has totally stopped rotating in prior.
1) The standard height of the presser foot lifted using the knee lifter is 10 mm.
2) You can adjust the presser foot lft up to 3 mm usng knee lfter adjust screw 1 .
3) When you have adjusted the presser foot lift to over 10 mm, be sure that the bottom end of needle bar
2 n ts lowest poston does not ht presser foot 3 .

5. InstaLLInG tHE tHrEaD stanD

2
1
1
– 3 –
3
) Assemble the thread stand unt as llustrated n
the figure shown on the left, and insert it in the
hole n the machne table.
2) Tghten locknut 1 enough to fix the thread stand.
3) For celng wrng, pass the power cord through
spool rest rod 2 .
2