Baud Rate Setup - GEM PTZ635 Handbook & Instructions

Camera Setup

Baud Rate Setup

Setting the Baud Rate is done using the SW2 set of four
dip switches. The Baud Rate can be set to 2400bps,
4800bps, 9600bps or Auto as shown below.
2400bps 4800bps
Terminal Resistor Setup
The PTZ635 has an in-built 120Ω terminal resistor.
When setting up multiple PTZs certain PTZs must
have their resistors enabled. When setting up PTZs
in a Daisy Chain formation the last PTZ must have its
resistor enabled. If you decide on a Star formation the
two furthest PTZs must have their resistors enabled.
Resistor
Disabled
6
9600bps Auto
Resistor
Enabled
Manual ref: XPTZ635
Daisy Chain Formation
Star Formation