Camera Setup - GEM PTZ635 Handbook & Instructions

Camera Setup

The cameras
Baud Rate,
are all controlled using dip switches located on the
underside of the dome, above the lens.
Unscrew the two screws and remove the clear plastic
cover to gain access to the dip switches. There are
to sets of dip switches.
camera's ID. While
SW2
camera's baud rate and terminal resistor.
ID Setup
The camera's ID (Address) is configured using the
SW1 set of eight dip switches. SW1 uses a binary
system where switch 1 represents the number 1,
through to switch 8 representing the number 128. Each
PTZ on a system must have its on unique ID. Examples
of how to set the camera's ID are shown on the right.
and
ID Terminal Resistor
is used to configure the
SW1
is used to configure the
www.systemq.com
PTZ number 1
PTZ number 3
PTZ number 5
PTZ number 7
PTZ number 254
PTZ number 2
PTZ number 4
PTZ number 6
PTZ number 8
PTZ number 255
5