Selecting Voices For The Parts - Yamaha PSR-S670 Owner's Manual

To listen to the demo phrases for each Voice
Press the [7 ] (DEMO) button to start the Demo for the selected Voice. To stop the demo, press the [7 ]
button again.
NOTE
Make sure that MENU 1 is shown at the bottom right corner of the display (page 24).
3
Play the keyboard.

Selecting Voices for the Parts

The Voices can be played via three keyboard parts: LEFT, RIGHT 1 and 2. You can combine these parts by using
the PART ON/OFF buttons to create luscious instrument textures and convenient performance combinations.
LEFT part
Left-hand (LOWER) section
• To play one single Voice on the entire keyboard:
Turn on the RIGHT 1 or 2 part.
• To play two different Voices in layer on the entire keyboard (Layer):
Turn on the RIGHT 1 and 2 parts.
• To play different Voices in the right- and left-hand sections of the key-
board (Split):
Turn on the LEFT and RIGHT (1 and/or 2) parts. The F#2 and lower keys are used
for the LEFT part while the upper keys (excluding F#2) are used for the RIGHT 1
and 2 parts. The key which divides the keyboard into the left-hand and right-hand
sections is referred to as the "Split Point."
1
Turn on the PART SELECT button corresponding to the part you
want to use.
NEXT PAGE
34
PSR-S670 Owner's Manual
For selecting the keyboard part to change the Voice
For turning on/off the keyboard parts
Right-hand (UPPER) section
Split Point (F#2 by default)
4
NOTE
The Voice name for each part can be
confirmed on the Main display
(page 18).
RIGHT 2 part
RIGHT 1 part
NOTE
The Split Point can be changed
(page 55).