System connections
Make sure to unplug the AC power cord before making any connections.
To select Line In function:
Press FUNCTION button (main unit) or AUDIO/LINE (IN-
PUT) button (remote control) repeatedly until Line in is
displayed.
Commercially
available
Subwoofer
Red
(Amplifier
Black
Built-In)
To right
speaker
AC outlet
(AC 100 -240 V ~
50/60 Hz)
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
■ Antenna connection
Supplied FM antenna:
Connect to the FM 75 ohms jack and position it where
reception is best.
External FM antenna:
Use an external FM antenna (75 ohms coaxial cable) for
better reception. Disconnect the supplied FM antenna wire
before use.
Supplied AM loop antenna:
Connect to the AM terminal and position it where reception
is best. Place it on a shelf, etc., or attach it to a stand or a
wall with screws (not supplied).
Installing the AM loop antenna
< Assembling >
wall
Note:
Keep the antenna away from the unit or AC power cord to
avoid noise pickup.
■ Speaker connection
+ speaker terminal
- speaker terminal
Audio cable
(not supplied)
< Attaching to the wall >
Screws (not
supplied)
red wire
black wire
Notes:
● No sound is heard from the subwoofer without a built-
in amplifier.
● Subwoofer Pre-out (audio signal): 200mV / 10k ohms
at 70 Hz.
To TV audio
output jack.
To LINE
AM loop
input jack
antenna
● Use speakers with an impedance of 6 ohms or more,
as lower impedance speakers can damage the unit.
● Do not mistake the right and the left channels. The
right speaker is the one on the right side when you
face the unit.
● Do not let the bare speaker
wires touch each other.
● Do not allow any objects to fall
into or to be placed in the bass
reflex ducts.
● Do not stand or sit on the
speakers. You may be injured.
■ Bluetooth standby mode
● The first time the unit is plugged in, it will enter the
Bluetooth standby mode. "Bluetooth Stby" will be dis-
played.
● To cancel the Bluetooth standby mode, press the ECO
button (remote control) during power standby mode.
The unit will enter the low power consumption mode.
● To return to the Bluetooth standby mode, press the ECO
button again.
■ AC power connection
After all connections have been made correctly, plug the
AC power cord into the AC outlet.
Note:
Unplug the AC power cord from the AC outlet if the unit will
not be in use for a prolonged period of time.
E-6
TV
FM
antenna
Label is located at the bottom of the
unit.
The specification label illustration or
location may be different for some
destinations.
Left
speaker
Installing the
supplied FM
antenna
Incorrect