Listening To The Radio - Sharp XL-HF102B Operation Manual

Listening to the radio

ON / STANDBY
■ Tuning
1
Press the ON/STANDBY button to turn the power on.
2
Press the TUNER [BAND] button (remote control) or
FUNCTION button (main unit) repeatedly to select FM
Stereo, FM Mono or AM.
3
● Manual tuning:
Press the TUNING (
tune in to the desired station.
● Auto tuning:
Press and hold the TUNING (
will start automatically and the tuner will stop at the first
receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING (
button again.
To receive an FM stereo transmission:
● Press the TUNER [BAND] button to select stereo
mode. "ST" indicator will be displayed. "
appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER [BAND]
button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clear-
er.
) button repeatedly to
or
) button. Scanning
or
or
" and " " will
■ Memorizing a station
You can store 40 FM and AM stations in memory and re-
call them at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the "MEM" and preset number
indicators disappear before the station is memorized,
repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorized for that
preset channel number will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
■ To recall a memorized station
Press the PRESET (
station.
■ To scan the preset stations
1
Press and hold the PRESET (
preset number flashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
desired station is located.
■ To erase entire preset memory
)
1
Press the ON/STANDBY button to turn the power on.
2
Press the FUNCTION button (main unit) repeatedly
or TUNER [BAND] button (remote control) to select
Tuner function.
3
In Tuner function, press and hold the CLEAR button
(remote control) until "Tuner Clear" appears.
E-14
) button to select the desired
or
) button until the
or
) button again when the
or