Table of Contents
Advertisement
Troubleshooting chart (continued)
■ Factory reset, clearing all memory
1
Press the ON/STANDBY button to turn the power on.
2
Press FUNCTION button (main unit) repeatedly or
AUDIO/LINE (INPUT) button (remote control) to enter
Audio In mode.
3
Press
button (main unit) once.
4
Press and hold button (main unit) until "RESET" appears.
Caution:
This operation will erase all data stored in memory includ-
ing clock, timer settings and tuner preset.
■ Before transporting the unit
Remove all devices connected to the unit. Then, set the
unit to the power standby mode. Carrying the unit with
other devices left connected or discs left inside might dam-
age the unit.
■ Care of discs
Discs are fairly resistant to damage. However mistracking
can occur due to accumulation of dirt on the surface.
● Do not mark on the non-label side of the disc from which
signals are read.
● Keep your discs away from direct sunlight, heat, and
excessive moisture.
● Always hold the discs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
Clean it with a soft, dry cloth, wiping straight out from the
center, along the radius.
Maintenance
■ Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
● Do not use chemicals for cleaning (gasoline, paint thin-
ner, etc.). It may damage the cabinet.
● Do not apply oil to the inside of the unit. It may cause
malfunctions.
■ Cleaning the CD pickup lens
In order to ensure proper operation of the CD player,
preventative maintenance (cleaning of the laser pickup
lens) should be performed periodically. Lens cleaners are
commercially available. Contact your local CD software
dealer for options.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification chang-
es for product improvement without prior notice. The per-
formance specification figures indicated are nominal val-
ues of production units. There may be some deviations
from these values in individual unit.
■ General
Power source
Power
consumption
Dimensions
Weight
Bluetooth
frequency band
Compatible
Bluetooth Profile
■ Amplifier
Output power
Output terminals Speakers: 6 ohms
Input terminals
E-19
AC 100 - 240 V ~ 50/60 Hz
Power on: 22 W
Width: 8 - 1/2" (216 mm)
Height: 3 - 4/5" (96 mm)
Depth: 11 - 1/4" (285 mm)
4.6 lbs. (2.1 kg)
2.400GHz - 2.480GHz
A2DP (Advanced Audio Distribution
Profile), AVRCP (Audio/Video
Remote Control Profile)
Bluetooth 2.1 +EDR
RMS: Total 50 W (25 W per
channel into 6 ohms at 1
kHz, 10% T.H.D.)
FTC:
19 W minimum RMS per
channel into 6 ohms from
20 Hz to 20 kHz, 1% T.H.D.
20Hz - 20kHz
Subwoofer Pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Audio In (audio signal):
500 mV/47 k ohms
Line in (Analogue input):
500 mV/47 k ohms
Hide quick links:
Advertisement
Table of Contents
