Operation And Use - DeLonghi DCH7093ER User Manual

descrIptIon
(see fig. 1)
a ON/STAND-BY button
B +/- adjustment buttons
c MODE button (selects the operating mode)
d "ECO plus" button
e Timer button
f
Swing button
g
Remote control receiver
H
Indicator light
I
Air intake grille
J
Filter
use
Installation
- The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the
same socket for other appliances.
electrical connection
- Before plugging the appliance into the mains socket, check
that the mains power supply corresponds to the value indi-
cated on the rating plate and that the mains power supply
is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC
ON RADIO INTERFERENCE SUPPRESSION.

operation and use

1. Plug into the mains socket.
2. The appliance emits a beep. The indicator light (H) co-
mes on and remains lit while the appliance is powered.
3.
The appliance switches to stand-by. A dot flashing on
the display means the tip over device has been activa-
ted. See paragraph: "Safety functions".
4. Press the ON/STAND-BY (a) to turn the appliance on.
It begins heating the room according to the current set-
tings.
5. Press the MODE button (c) to select one of the following
operating modes:
fan
freeze prevention
Heating 1
Heating 2
Heating 3
5.1 fan
In this mode, only the fan operates and the appliance does
not heat the room.
description/use
5.2 freeze prevention
In this mode, the appliance keeps the room at a temperature
of 7°C to avoid freezing.
5.3 Heating 1, 2 and Heating 3
In this mode, the desired temperature can be selected by
pressing the adjustment buttons + and – (B):
Heating 1 (low power)
-
The appliance operates at low power, reducing noise
levels and energy consumption to a minimum.
- Heating 2 (medium power)
The appliance operates at medium power.
- Heating 3 (high power)
The appliance operates at high power to heat the room
rapidly.
6. "eco plus" function
The "ECO plus" function is available in Heating 1, 2 and 3
modes only.
To activate the function, press the "ECO plus" button (d).
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
While the "ECO plus" function is active, the appliance may
switch automatically to a lower heating power than the one
displayed. This may happen a number of times in an hour.
7. To distribute the air flow over a wider surface, press the
swing button (f)
the right and left. To stop the appliance in the desired
position, simply press the swing button (f) again.
8. To turn the appliance off, press the ON/STAND-BY button
(a). The display may visualize a countdown for about 6
seconds.
please note: Room temperature can be displayed in either
°C or °F. To change the unit of measurement for the tempera-
ture, press the + button for a few seconds, then release.
digital 24 h timer
This function can be activated from any operating mode.
auto-start: with the appliance in STAND-BY, press the timer
button (e) . The
the time remaining before the appliance comes on. To adjust
the timer, use the adjustment buttons + and - (B), then wait
a few seconds for the setting to be memorised. The stand-by
light (H) is displayed together with the
that the timer has been set. When the programmed time
8
. The appliance starts swinging to
symbol is displayed together with
symbol, indicating
en