Monitor Display - Ricoh Pentax Q-S1 Start Manual

0 Green/Delete button (M/L)
Resets the values being adjusted. Also, you can assign
a function to this button.
Press to delete images during playback. (p.25)
a OK button (E)
When the control panel or a menu is displayed, press
this button to confirm the selected item.
b Four-way controller (ABCD)
Displays the Sensitivity, White Balance, Flash Mode
or Drive Mode setup menu. (p.8)
When the control panel or a menu is displayed, use
this to move the cursor or change the item to set.
Press B during playback to display the playback mode
palette. (p.26)
c MENU button (F)
Displays a menu. Press this button while the menu
is displayed to return to the previous screen. (p.9)
d INFO button (G)
Changes the style of the display on the monitor. (p.5, p.7)
About the four-way controller
In this manual, each button of
the four-way controller is indicated
as shown in the illustration on
the right.

Monitor Display

Capture Mode
When the camera enters capture mode, the subject and the
current shooting function settings are displayed on the monitor.
This state is referred to as "standby mode". Press G
in standby mode to display the "control panel" and change
settings. (p.8) If you press G while the control panel is
displayed, you can change the type of information displayed
in standby mode.
1/ 1/
2000 F2.8 2000 F2.8 1600 1600 37 37
Standby mode
(Standard Information Display)
Standard Information Display Standard Information Display
1/ 1/
2000 F2.8 2000 F2.8
Shooting Info Display
selection screen
Custom Image Custom Image
G Bright Bright
Control panel
G
1600 1600 37 37
37 37
5