Linksys EtherFast BEFSR11, BEFSR41 User Manual page 34

EtherFast Cable/DSL Routers
should be the Router's IP Address, and DNS (in "More".)
• Same as above, check the same setup values in the Status Monitor page
of the Cable/DSL Router.
4. When I enter a URL or IP address, I get a time out error.
• Check if other PCs work. If they do, ensure that your workstations IP
settings are correct (IP address, Subnet Mask, Default gateway and
DNS)
• If the PCs are configured correctly, but still not working, check the
Cable/DSL Router. Ensure that it is connected and ON. Connect to it
and check its settings. (If you cannot connect to it, check the LAN and
power connections.)
• If the Cable/DSL Router is configured correctly, check your Internet
connection. (DSL/Cable modem etc.) to see that it is working correctly.
5. I can't obtain an IP address from my cable or DSL modem.
• Ensure that all of your cabling is properly connected and that all of the
router's WAN and LAN LEDs are correctly illuminated.
• Power down your cable or DSL modem for a few seconds. Turn it back
on. After the modem goes through its self-test, check to see if you now
have an IP address.
• Ensure that your cable or DSL modem is DHCP-capable.
• You may have to enter the router or host name in the Setup page of the
Router's web-based utility. Go to page 18 for more information.
• Your ISP may require Mac Addresses. Check with your ISP. This
address can be obtained in the Status screen of the Router's Web-based
Utility.
31