Linksys EtherFast BEFSR11, BEFSR41 User Manual page 22

EtherFast Cable/DSL Routers
• DNS (Domain Name Server) IP Address Your ISP will provide you with
at least one DNS IP Address. If set to Obtain an IP address automatically,
these values are assigned by your ISP.
You can test and see if the above settings are correct by successfully connect-
ing to the Internet.
• PPPoE (Point-to-Point Protocol over Ethernet) Some DSL-based ISPs
use PPPoE to establish communications with an end-user. If you are con-
nected to the Internet through a DSL line, check with your ISP to see if
they use PPPoE. If they do, you will have Enable it. To enable PPPoE:
1. Choose the Enable option within the PPPoE area of the Setup screen.
2. Enter the User Name you use to log onto your Internet connection.
3. Enter your corresponding Password.
• Connect on Demand If you aren't actively using the Internet, you can
configure your Router to cut your connection with your ISP after a certain
period of time. If you have been disconnected due to inactivity, Connect
on Demand enables your Router to automatically re-establish your con-
nection as soon as you attempt to access the Internet again. If you wish to
activate Connect on Demand, choose the Enable option.
• Max Idle Time The Max Idle Time is the amount of time you would like
to pass before the Router drops your Internet connection due to inactivity.
If you want your Internet connection to remain on at all times, enter zero
(0) in this field.
19