Linksys EtherFast BEFSR11, BEFSR41 User Manual page 11

Full/Col
10/100
The WAN Indicators
Link
Act
Diag
8
Green. The Full/Col LED also serves two purposes. If this
LED is continuously illuminated, a connection is being suc-
cessfully maintained through the LAN port. If the LED is
flickering, the connection is experiencing collisions.
Infrequent collisions are normal. If this LED is flickering
too often, there may be a problem with your connection.
Check the Troubleshooting section on page 30 if you think
there is a problem.
Orange. The 10/100 LED illuminates when a successful
100Mbps connection is made through the corresponding
port. If a 10Mbps connection is being made, the light will
not be illuminated.
Green. The Link LED illuminates when a successful con-
nection is made between the Router and your Broadband
device or network.
Green. The Act LED flickers when the Router is sending or
receiving data over the broadband port.
Red. The Diag LED illuminates when the Router goes
through its self-diagnosis mode during boot-up. It will turn
off upon successful completion of the diagnosis. If this
LED stays on for an abnormally long period of time, refer
to Troubleshooting on page 30.
Instant Broadband Series