Kenwood KDC-U463 Instruction Manual page 15

INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
Part list for installation
(A) Faceplate (B) Trim plate
/
/
/
(E) Wiring harness
Do the required wiring.
( 16, 17)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
(C) Mounting sleeve (D) Extraction key
/
/
/
/
When installing without the mounting sleeve
(for / /
)
1 Remove the mounting sleeve and trim plate from the
unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (commercially available).
The following screws are supplied for
Round head screws (M5 × 8 mm)
Flat head screws (M5 × 8 mm)
Sems screws (M4 × 8 mm)
Use only the specified screws. Using wrong screws might damage the unit.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes
on both sides of the
trim plate, then pull it
out.
3
Insert the extraction
keys deeply into
the slots on each
side, then follow the
arrows as shown on
the right.
/ /
:
× 4
To secure the
mounting bracket
× 4
To secure the ground
× 1
wire (black)
15
ENGLISH