Chapter 4: Using The Setup Wizard To Configure Windows 98Se, Me, And 2000 - Linksys WPC11 User Manual

Chapter 4: Using the Setup Wizard
to Configure Windows 98SE, Me,
and 2000
The Adapter's Setup Wizard will guide you through the installation procedure
for Windows 98SE, Me, and 2000. The Setup Wizard will install the WLAN
Monitor and driver, as well as configure the PC Card.
Important for Windows XP users: Do NOT run the Setup Wizard.
Proceed directly to "Chapter 5: Hardware Installation."
Important for Windows 98SE, Me, and 2000 users: You must run
the Setup Wizard to install the software before installing the hardware.
Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup
Wizard should run automatically, and Figure 4-1 should appear. If it does not,
click the Start button and choose Run. In the field that appears, enter
D:\setup.exe (if "D" is the letter of your CD-ROM drive).
Figure 4-1
5
Instant Wireless ® Series
Wireless-B Notebook Adapter
1. To install the PC Card, click the Install button on the Welcome screen,
Figure 4-1. Click User Guide to view the User Guide or click Exit to exit
the Setup Wizard.
2. After reading the License Agreement on the following screen, shown in
Figure 4-2, click the Next button to continue the installation, or click the
Cancel button to end the installation.
Figure 4-2
3. The next screen in the Setup Wizard, shown in Figure 4-3, will ask you to
choose a wireless mode. Click the Infrastructure Mode radio button if you
want your wireless computers to network with computers on your wired
network using a wireless access point. Click the Ad-Hoc Mode radio but-
ton if you want multiple wireless computers to network directly with each
other.
6