Chicago Electric 61441 Owner's Manual & Safety Instructions page 15

7. Remove the Wire Board, then use tip of flat-
edge screwdriver (not included) to carefully
pop the Holder's spring off the top of the
Carbon Brush (15). See Figure N.
carbon Brush
Holder Spring
Figure N
cAUTION! The spring must be clear of the
Holder lip to remove Carbon Brush.
8. Use the screwdriver to slide the Carbon Brush from
the Holder. Then replace with new Carbon Brush.
9. Snap spring back into place and use
Screw to replace Wire Board.
Item 61441
carbon
Brush (15)
Wire Board
(13)
For technical questions, please call 1-888-866-5797.
10. To better access the second Carbon Brush,
turn the Breaker Hammer over. Repeat Steps
6 to 9 to replace second Carbon Brush.
11. Once both Carbon Brushes have been
replaced, slide Gearbox shut.
cAUTION: When closing Gearbox, make
sure tab along rim of Gearbox aligns with
the slot in the housing. See Figure O.
Housing
Slot
Figure O
12. Use the four screws to fasten the Gearbox back
into place. Then replace Left Handle and fasten
that into place against Gearbox. Replace Cover
and fasten it into place using the Screws.
Gearbox
Tab
Page 15