( Using Bluetooth wireless technology
Section
)C!III
Adjusting the intended party's
listening volume
Tc maintain the good speech quality. this unit
can adjust the intended party's listening vo-
lume. If the volume is not enough for intended
p<u1y. adjust this function.
1
Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2
Use MULTI-CONTROL to select
END VOLUME.
3
Push MULTI-CONTROL left or right to
select the desired setting.
'--2-3-4-5
•
This function can be performed even while
talking on the phone.
•
Settings can be stored for each device.
Switching the ring tone
You can select whether to use this unit's ring
t018 or not. If this function
1$
set to on. nng
t018 from thiS unit will sound.
1
Display the function menu.
Rf'fer to Introduction to advanced operations
or the previous page.
2
Use MULTI-CONTROL to select
RING TONE.
3
Press MULTI-CONTROL to turn ring tone
Orl.
To turn C1ng tone off press MULTI-CONTROL
agam.
Making a call by entering
phone number
~
Important
Be sure to park your vehicle and apply the park·
in~J
brake when pedormlng thiS operation.
1
Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2
Use MULTI-CONTROL to select
NUMBER DIAL.
3
Push MULTI-CONTROL up or down to
select a number.
4
Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
•
Up
to
32 digits can be enter·ed.
5
When you finish entering the number.
press MULTI-CONTROL.
Call confirmation appears.
6
Press MULTI-CONTROL to make a call.
7
To end the call, press PHONE!'.:!!
BT MENU.
Setting the private mode
During a conversation. you can switch to prj·
vate mode (talking directly on your cellular
phone).
1
Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2
Use MULTI-CONTROL to select PRIVATE.
3
Press MULTI-CONTROL to turn private
mode on.
To turn private mode off. press
MULTI-CONTROL agam. ~
m
"
CO
en
J
En
®