Connecting To A Bluetooth Device Automatically; Displaying System Version For Repair; Displaying So (Bluetooth Device) Address; Editing Device Name - Pioneer DEH-P6100BT Operation Manual

Section
D (
Using Bluetooth wireless technology )
5 Push MUlTI-CONTROL up or down to
select the service.
PHONE-AVRCP~A2DP
• . . *"
IS
displayed on the connected service
• Profile that is not compatible with the can·
nected device cannot be selected,
6 Press MULTI-CONTROL to start or stop
the selected service.
Connecting to a Bluetooth
device automatically
It
is possible to set the automatic connection
between your Bluetooth device and this unit. If
this function
IS
set to on. connection between
your Bluetooth device and this unit will take
place automatically as soon as the two devices
are less than a few meters apart,
• Initially. this function is set to on.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 27.
2 Use MULTI-CONTROL to select
A.CONNECT.
3 Press MULTI-CONTROL to turn auto-
matic connection on.
If your Bluetooth device
IS
ready for Bluetooth
Wireless connection. connection to this unit is
automaticallyestabllshed.
• To turn automatic connection off. pl'ess
MULTI-CONTROL again.
Displaying system version for
repair
Should this unit fails to operate properly and
you consult your dealer for repair. you may be
asked to indicate the system versions of this
unit and of Bluetooth module. You can display
the versions and confirm them.
1 Display the connection menu.
Refer to Introduction to connectIOn operations
on page 27
@
En
2 Use MULTI-CONTROL to select
BT VER. INFO.
The system (microprocessor) version of this
unit is displayed.
3 Push MUlTI-CONTROL left to switch to
the version of the Bluetooth module of this
unit.
• Pushing
MULTI-CONTROL
ngllt returns to the
system vel'Slon of thiS unit.
Displaying BD (Bluetooth
Device) address
This unit displays the SD address of this unit
1 Display the connection menu.
Refer to Introduction to connection operations
on page 27
2 Use MULTI-CONTROL to select
DEVICE INFO in the function menu.
3 Push MULTI-CONTROL left to switch to
the BD address.
12-digit hexadecimal string is displayed.
• Pushing
MULTI-CONTROL
fight returns
to
the
device name
Editing device name
You can edil the device name.
The deVice name
IS
set to PIONEER BT as de·
fault.
1 Display the connection menu.
Refer to Introduction to connection operaflons
on page 27.
2 Use MULTI-CONTROL to select
DEVICE EDIT.
3 Press DISP/SCRL to select the desired
character type.
P"ess DISP/SCRL repeatedly to
swdeh
IleINe,·"
the follOWing chafacter types.
Alphabet-Numbers