Using Your Capsule Machine - Sunbeam Multi-Capsule CM2000 Instruction Booklet

Using Your Capsule Machine

Inserting a capsule cartridge
Note: The multi-capsule machine already
has the Nespresso* cartridge inserted into
the machine ready for use. To change to
a different capsule system, please see the
following section on changing your capsule
system.
1. Remove water tank from the back of the
machine and fill with fresh water.
Replace water tank. See figure 1.
2. Turn power switch on. This is located at
the right rear of the machine (below the
water tank)
3. Press power button on the machine.
See figure 2.
Note: Button lights will flash while
the machine is heating to the correct
temperature. When flashing stops, the
machine is ready to use.
4. Open the handle. See figure 3.
5. Insert coffee capsule into the capsule
cartridge. See figure 4.
Figure 1
Note: If you would like to use a different
capsule then please refer to "Changing the
capsule system" procedure on page 7.
* Capsule trade marks are owned by third parties & are not related
to Sunbeam
(see Disclaimer on page 4).
Figure 2
Figure 3
Figure 4
5