Specifications; Standard Equipment; Electromagnetic Compatibility (Emc) - RIDGID RE 6 Manual Manual

QCS Type
Label
QCS Sleeve
LED
Pressure
Work
Release
Light
Run
Button
Switch
Warning Labels
Figure 1 – RE 6 Electrical Tool
Figure 2 – LED Diagnostic Display

Specifications

RE 6 and RE 60 Electrical Tools:
RE 6
Piston Force ...............13,500 lbf
6-ton
(60kN)
Piston Travel ..............1.26"
(32mm)
QCS Type ..................6T QCS
Duty Cycle..................
Motor
Voltage ...................18V DC
Amperage ...............18 Amp
Power .....................324 Watts
Battery........................18V Li-Ion, Rechargeable
Battery
Operating Temperature
Range ...........................15° F to 122° F (-10° C to 50° C)
Sound Level ................92 dBa
Vibration ......................59 in/s
Weight (with Battery)...6.41 lbs (2.91 kg)
Fabric Loop
Battery
LED
ON/OFF
Button
RE 60
60kN
6-ton
(13,500 lbf)
24mm
(0.94")
60kN QCS
3 Cycles per minute
2 (1.5 m/s 2 )
RE 6/RE 60 Electrical Tool
Electric Tool serial number plate is located on the rear of
the tool (Figure 3) . The first 4 digits indicate the year
and month of the manufacture. (12 = year, 06 = month).
ON/OFF
Button
Figure 3 – Machine Serial Number

Standard Equipment

The Electrical Tool, if ordered with batteries, comes with
2.0Ah batteries. 4.0Ah batteries are available as acces-
sories (See Accessories) . Higher amp hour batteries
allow more tool cycles per charge, but also weigh more.
The RIDGID ® Model RE 6/RE 60 Electrical Tool comes
with the following:
• RIDGID ® Model RE 6/RE 60 Electrical Tool
• Operator's Manual
NOTICE Selection of appropriate materials and joining
methods is the responsibility of the system designer
and/or installer. Before any installation is attempted, care-
ful evaluation of the specific service environment, includ-
ing chemical environment and service temperature, should
be completed. Consult connector manufacturer for selec-
tion information.
Electromagnetic Compatibility
(EMC)
The term electromagnetic compatibility is taken to mean
the capability of the product to function smoothly in an
environment where electromagnetic radiation and elec-
trostatic discharges are present and without causing elec-
tromagnet interference to other equipment.
The RIDGID Model RE 6 and RE 60 Electri -
®
NOTICE
cal Tools conform to all applicable EMC standards.
However, the possibility of it causing interference in other
devices cannot be precluded. All EMC related standards
that have been tested are called out in the tool's technical
document.
5