Setup Option Descriptions - Toshiba T6400 Maintenance Manual

6. If the new values are correct in SETUP and the following message is displayed, proceed to
step 7. Otherwise, proceed to step 8.
Insert Password Disk if necessary.
The above message is displayed when you enable the Power On Password option.
7. Insert a diskette in drive A. This diskette will become your password service disk that you
can use to start up the computer if you forget the password.
NOTE: The contents of the diskette will be erased when the password service disk is
created. You can insert either an unformatted or formatted diskette for the password
service disk.
8. Press Y in response to saving the SETUP changes. If you inserted a diskette for the pass-
word disk procedure, the SETUP will create the password service disk. When the procedure
is completed, the following message is displayed.
Remove the Password Service Disk and Press any key.
Remove the diskette and press any key. The diskette should be stored in a safe place.
9. The new SETUP values are now recorded in CMOS memory and the system reboots.

3.24.4 SETUP Option Descriptions

This section explains the alternate settings for each SETUP option.
MEMORY
This group of options displays the configuration of the memory installed in the T6400. This is
only for your information and cannot be changed through the SETUP function.
TOTAL
The SETUP function automatically calculates the total amount of memory that is built into
the T6400 and displays it. This is only for your information and cannot be changed.
BASE
The SETUP function displays the amount of base (conventional) memory, which is 640KB.
This is for your information only and cannot be changed.
EXTENDED
The SETUP function calculates the amount of extended memory. This is only for your
information and cannot be changed.
3-56