Id Remote Control - Planar RA-Series User Manual

Table of Contents

Planar RA-Series

2.3.2. ID Remote Control

You can set the remote control ID when you want to use the remote

control on specific displays.

Entering/Leaving ID Mode

To enter ID mode: Press and hold the [ID ] button until the red LED

blinks twice

To leave ID mode: Press and hold the [NORMAL] button until the

green LED blinks twice

Programming ID Mode

To assign an ID to a remote control

1. Enter ID mode

2. Press and hold the [ID SET] button until the red LED turns on

3. Using the numeric keypad, enter the desired ID

4. Press the [ENTER] button to confirm ID

5. The red LED will blink twice when ID has been confirmed

NOTE:

• To cancel or stop programming an ID, press the [ID SET] button.

• Programming of the remote will be automatically canceled if no

buttons are pressed for 10 seconds.

Table of Contents