Page 3
Return command: 07 IDT 00 CMD REP 08 (8 bytes) Serial Port Setting Baud Rate Data Bit Parity Bit Stop Bit 115200 None Note: Baud rate can be set to 38400, 19200 or 9600 to match the monitor baud rate setting. EP4650 and EP5550 RS232 User Guide...
Page 4
On (Back Light) Display 0~100 Current value Contrast 43 4F 4E Adjustment 0~100 Current value 48 55 45 0~100 Current value Saturation 53 41 54 User 6500K 9300K 43 4F 54 3200K 5000K 7500K EP4650 and EP5550 RS232 User Guide...
Page 5
Component 1 PIP source HDSDI 1 selection 50 49 4E HDSDI 2 HDMI 1 HDMI 2 Displayport PIP Position Bottom-left PIP Position Bottom- right PIP position 50 50 4F PIP Position Top-left PIP Position Top-right EP4650 and EP5550 RS232 User Guide...
Page 6
Lock keys 13 bytes Read Serial Number 53 45 52 13 bytes Read Model Name 4D 4E 41 6 bytes Read Firmware Version 47 56 45 Current value Read RS232 table 52 54 56 Version EP4650 and EP5550 RS232 User Guide...
Page 7
44 49 56 Note 1 Y: 1-5 Low quarter is Y: 3-0 bit DVI Indemnity Off 44 49 44 DVI Indemnity On 0-30 Current value Integral part of Power 50 4F 44 On Delay (0-30 sec.) EP4650 and EP5550 RS232 User Guide...
Page 8
53 46 4D 0~23 0~23 Monday On Hour 4E 4E 48 0~59 0~59 Monday On Minute 4E 4E 4D Monday 0~23 0~23 Monday Off Hour 4E 46 48 0~59 0~59 Monday Off Minute 4E 46 4D EP4650 and EP5550 RS232 User Guide...
Page 9
※: The RS232 transition will be blocked for around six seconds after a power on/off command has been performed. Note 1: In broadcast setting mode, this command is used to auto arrange the Division X/Y. (The Value Byte needs to be 0x11.) EP4650 and EP5550 RS232 User Guide...
Go to www.planarpartners.com. Enter your login and password information. Navigate to the section that contains software updates and then look for EP4560/EP5550. From the list of available software, click on the tool you need. EP4650 and EP5550 RS232 User Guide...