LG 42PJ350 Training Manual page 71

Y - Drive Board P106 Connector to P211 Y - SUS (Logic and FG5V)
Y - Drive Board P106 Connector to P211 Y - SUS (Logic and FG5V)
TIP: This Connector does not come with a new Y-SUS or Y-Drive.
TIP: Use Scan Screw Lug on the Y-SUS to test for Y-Scan signal if the Y-Drive board is removed.
P106 P211
Y-Scan
Signal
FG5V (4.9V) measured from Pins 15 or 16
to Floating Gnd.
For Floating Ground, use any screw on
the far left hand side of the Y-SUS board
except the one just above P106, this is the
Y-Scan output.
Y-SUS
Y-Drive
Board
Board
71 August 2010 42PJ350 Plasma