Installation Procedure - Toshiba RAS-M24N3KV2-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
Flat head
8
wood screw
10 Battery cover
5
Filter
9
Flat head wood screw
Batteries
3
2
Wireless remote control
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
Remark :
• Detail of accessory and installation
parts can see in the accessory sheet.
• Some pictures might be different from
the actual parts.
Before installing the wireless remote controller
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (− ) positions.

10. INSTALLATION PROCEDURE

6
Filter
8
Flat head
wood screw
2 Wireless remote controller
– 38 –
Hook
1
Installation
plate
Shield pipe
Remote control holder
4
3 Batteries
FILE NO. SVM-12087
For the rear left and left piping
Wall
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Rear
Left
Bottom right
left
Bottom left
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam