One Touch Comfort; Hi Power Mode - Toshiba RAS-M24N3KV2-E Service Manual

Item
16. One Touch One touch comfort is the fully automated operation that
Comfort is set according to the preferable condition in a region.
∗ AUTO/L: Fan operates depends on the setting

17. Hi POWER Mode

([Hi-POWER] button on the remote controller is
pushed)
When [Hi-POWER] button is pushed while the indoor
unit is in Auto, Cooling or Heating operation, Hi
POWER mark is indicated on the display of the remote
controller and the unit operates as follows.
1. Automatic operation
2. Cooling operation
3. Heating operation
4. The Hi POWER mode can not be set in Dry
Operation flow and applicable data, etc.
Fan
Operation
AUTO *AUTO/L
0 12
temperature and room temperature.
During the One Touch Comfort mode if the indoor unit
receives any signal with other operation mode, the
unit will cancel the comfort mode and operates
according to the signal received.
• The indoor unit operates in according to the
current operation.
• The preset temperature drops 1 degree
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increases 1 tap.
• The preset temperature increases 2 degree
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increases 1 tap
operation
L
25 Time after operation
starts (min)
– 31 –
FILE NO. SVM-12087
Description
Operation condition for model to
Europe market
When an indoor unit receives "One
Touch Comfort Signal" from the
remote controller, the indoor unit
operates as following.
1) Air conditioner starts to operation
when the signal is received, even if
the air conditioner was OFF.
2) Operation mode is set according to
room temperature, the same as
AUTO mode.
3) Target temperature is 24°C.
4) Louver position is set as stored
position of the operating mode.
5) Fan is controlled as followings.