Panasonic WV-NP244 Operating Instructions Manual page 19

Step 1
Start the Panasonic IP setting software.
Step 2
Click the [IP setting] button after selecting
the MAC address/IP address of the camera
to be configured.
Note:
When using a DHCP server, the IP
address assigned to the camera can be
displayed by clicking the [Refresh] but-
ton of the IP setting software.
Step 3
Complete each network setup item and click
the [Apply] button.
Note:
When using a DHCP server, it is possible
to set "DNS" to "AUTO".
Important:
• It may take for around 30 seconds to
complete to upload the settings to the
camera after clicking the [Apply] button.
The settings may be invalidated when
the AC adapter or the LAN cable is dis-
connected before
upload. In this case, perform the settings
again.
• When using a firewall (including soft-
ware), allow access to all UDP ports.
completing the
19