Ftp Server Configuration Commands - NEC SOPHO IP 5000 Command Reference Manual

3.5

FTP Server Configuration Commands

display ftp-server
display ftp-user
Command Reference Guide
Syntax
display ftp-server
View
Any view
Parameter
None
Description
Using the display ftp-server command, you can display the parameters of the
current FTP server.
After the FTP parameters are configured, this command can be used to display
the configuration results.
Example
Display the FTP parameters configured.
<NEC-PHILIPS> display ftp-server
Ftp server is running
Max user number5
User count2
Timeout(minute)30
The information shown above indicates that the FTP server has started and can
support up to 5 log-on users simultaneously and now there are two log-on users
and the timeout of an FTP user is 30 minutes.
Syntax
display ftp-user
View
Any view
Parameter
None
Description
Using the display ftp-user command, you can display the parameters of
the current FTP user.
Example
Display the FTP user parameter configuration.
<NEC-PHILIPS> display ftp-user
usernamehost porttopdiridle
NEC-PHILIPS 10.110.3.51074c:/NEC-PHILIPS2
The information shown above indicates that a connection between an FTP user
named NEC-PHILIPS and the FTP server has been established. the IP address
of the remote host is 10.110.3.5 and the remote port number is 1074. the
authorization directory is flash:/NEC-PHILIPS and so far the user has not sent
any service request to the FTP server for 2 minutes.
SOPHO
IP 5000/SOPHO IP6000
53