Logic-Channel Interface; Configuration Command Of Virtual Template And Virtual Access Interface - NEC SOPHO IP 5000 Command Reference Manual

4.15

Logic-Channel Interface

interface logic-channel
4.16 Configuration Command of Virtual Template and Virtual
Access Interface
broadcast-limit link
Command Reference Guide
Syntax
interface logic-channel interface-number
undo interface logic-channel interface-number
View
System view
Parameter
interface-number: Number of logic-channel, in range of 0~1023.
Description
Using the interface logic-channel command, you can create logic-channel
interface. Using the undo interface ethernet command, you can delete logic-
channel interface.
Once it is created, a logic-channel interface stays in UP state until it is deleted.
Example
Create the logic-channel interface 100.
[NEC-PHILIPS] interface logic-channel 100
[NEC-PHILIPS-Logic-Channel100]
Syntax
broadcast-limit link number
undo broadcast-limit link
View
Virtual template view
Parameter
number: Maximum link number that the virtual template supports for sending
multicast or broadcast packets, ranging from 0 to 128. The default value is 30.
Description
Using the broadcast-limit link command, you can configure the maximum link
number that virtual template supports for sending multicast or broadcast
packets. Using the undo broadcast-limit link command, you can restore the
default configuration.
When there are many links on a virtual template, sending multicast or broadcast
packets from each link may influence the function of the system. In this case,
the broadcast-limit link command can be used as a limitation, so that
multicast or broadcast packets are discarded if the link number exceeds the
limitation.
Example
Configure maximum link number of virtual template 1 supporting sending
multicast or broadcast packet to be 100.
[NEC-PHILIPS] interface virtual-template 1
[NEC-PHILIPS-Virtual-Template1] broadcast-limit link 100
SOPHO
IP 5000/SOPHO IP6000
184