System Maintenance & Management Commands; Debugging - NEC SOPHO IP 5000 Command Reference Manual

3. SYSTEM MAINTENANCE & MANAGEMENT COMMANDS
Network Test Tool Commands
3.1

Debugging

Debugging
display debugging
Command Reference Guide
Syntax
debugging { all | module-name [ debug-option1 ] [ debug-option2 ] ...}
undo debugging { all | module-name [ debug-option1 ] [ debug-option2 ]
...}
View
User view
Parameter
all: Enables or disables all the debugging switches.
module-name: Module name.
debug-option: Debugging option.
Description
Using the debug command, you can enable system debugging. Using the
undo debug command, you can disable system debugging.
By default, the system disables all the debugging switches.
The router system provides a variety of debugging functions mainly for the
support technicians and senior maintenance engineers to perform network
fault diagnosis.
Enabling debugging will generate a large amount of debugging information that
can result in a decrease in system efficiency. This is especially the case when
the command debugging all is executed to enable all the debugging switches.
An extreme aftermath after doing so can be system paralysis. For these
reasons, you are recommended not to use the command debugging all. On
the contrary, using undo debugging all will bring you great convenience
because you can disable all the debugging switches at once rather than
disabling them one by one.
For related command, see display debugging.
Example
Enable IP packet debugging.
Syntax
display debugging [ interface interface-type interface-number] [ module-
name ]
View
Any view
Parameter
module-name: Module name.
interface-type: Interface type.
SOPHO
IP 5000/SOPHO IP6000
17