Vermont Castings BC36MH Installation & Operating Manual page 18

BC36MH, BC42MH Woodburning Fireplace
WHITE
Fig. 29 FK12 wiring.
Fan/Blower Replacement
If your fireplace has glass doors, it is recommended the
doors and lower track be completely removed for ease
of access.
1. Remove the grate and hearth brick by carefully lifting
out of the fireplace.
2. Remove access panel by carefully pulling up and out
from the back center edge of the panel until the tabs
at each side are free. Use caution - the panel edges
may be sharp. (Fig. 30)
Access Panel
Fig. 30 Remove hearth brick and access panel.
AC542
BFK1 FAN KIT FOR BR/BC
3. Release the blower assembly from the Velcro
HEARTH BRICK REMOVAL
tainers. Disconnect the two (2) motor wires and the
11/3/97
green ground wire.
4. With the new blower, reconnect the two (2) motor
wires and the green ground wire.
5. Center fan/blower assembly over the mounting loca-
tion and secure with the Velcro
the fireplace.
18
Receptacle
Junction
BLACK
ON OFF
ON/OFF Rocker Switch
FP2463
FK12 wiring
Hearth Brick
AC542
re-
®
strips at the back of
®
120VAC
Box
BLACK
GREEN
BLACK
Prior to reinstalling the access panel and the hearth
brick, it is advisable to operate the switch on and off to
assure fan operation. If the fan does not operate and
you are assured that 115V AC power is present at the
receptacle, contact your dealer.
Reinstall the access panel and hearth brick by reversing
order of removal.
WARNING: Never contact blower wheels during opera-
tion.
Recommended Operating Procedures
Light your fireplace with the fan off. After the fire has
been burning for abut 30 minutes, turn the fan on.
Heated air should be delivered at the outlet grille.
Maintenance
Periodically check the fan assembly and remove any
dust, dirt or obstructions.
Replacement parts and service may be obtained
through your distributor or dealer. If additional informa-
tion or an instruction manual is needed, contact:
Vermont Castings Group
149 Cleveland Drive
Paris, KY 40361
www.vermontcastingsgroup.com
7412972