Fold-Down Front Passenger; Seatback; Multiflex™ Split-Folding And Sliding Rear Seat - Chevrolet 2008 Equinox Get To Know

16
Getting to Know Your Equinox

Fold-Down Front Passenger

Seatback

The front passenger seatback can be
folded flat, allowing you to carry extra-
long cargo, such as skis, lumber or an
eight-foot ladder.
The back of the seat has a durable plas-
tic surface that can be used as a desk
or table when the vehicle is stationary.
To fold the seatback forward:
1. Lift the release bar located under the
front of the seat cushion.
2. Slide the seat completely rearward;
then release the bar.
3. Push and pull on the seat to ensure it
is locked in place.
4. Lift the recliner lever located on the
right side of the seat cushion fully
upward and fold the seatback forward
until it locks in the folded position.
5. Pull up on the seat to ensure it is
locked in place.
Note: The Equinox Sport front passen-
ger seat folds down, but does not fold
fully flat into a locked position.
To return the seatback to an upright
position:
1. Lift the recliner lever upward; then
use your other hand to raise the seat-
back to an upright position.
2. Push and pull on the seatback to
ensure it is locked in place.
See Section 1 of your Owner Manual.
MultiFlex™ Split-Folding and
Sliding Rear Seat
Your vehicle's rear seatbacks can fold
forward to provide additional cargo
space. The seatbacks also include two
recline positions for greater passenger
comfort. In addition, the seat can travel
nearly eight inches — two inches for-
ward and six inches backward.
Note: Before folding or reclining the
seatback(s), ensure that all three rear
safety belts are unbuckled and that the
front seatbacks are not reclined.
To fold the seatback(s) down:
1. Lift the lever located on top of the
seatback.
2. Tilt the seatback forward and down.
To recline the seatback(s):
1. Lift and hold the lever located on top
of the seatback.
2. Tilt the seatback rearward; then
release the lever when the seatback
is in the desired position.