Call All Available Status Indicator - Motorola DLR1020 User Manual

Call All Available Status Indicator

Note: To initiate Call All Available, press the Top Button followed by the PTT button to talk to all available users
in different channels.
Call All Available Status
Call All Available initiated (using
Top Button press) – Initiator party
Call All Available conversation
initiated (using the PTT button) –
Initiator party
Call All Available Call notification –
Receiver party
Call All Available conversation in
progress – Both parties
End of Call All Available – Both
Note: Top Button must be pre-programmed to Call All Available via Advanced Configuration or CPS. Call All
Available times out after 4 seconds of inactivity (no transmission detected). This table applies only to
cases in which Call All Available is programmed to the Top Button. Call All Available can also be
programmed to a radio channel. Refer to "Customer Programming Software (CPS)" on page 83 for more
information.
72
English
Table 3: Call All Available Status Indicator
Top Button LED Indicator
parties
Blink Orange
Solid Orange
Solid Orange
Solid Orange
Off
Voice Prompt or Tone
"Call All Available"
Standard TPT
Standard TPT
Standard TPT
None