Table of Contents
Advertisement
Refer to the following table for clearance between roof and
termination.
ROOF PITCH
MINIMUM HEIGHT ABOVE ROOF
FLAT - 7/12
7/12 - 8/12
8/12 - 9/12
9/12 - 10/12
10/12 - 11/12
12/12 - 14/12
14/12 - 16/12
16/12 - 18/12
18/12 - 20/12
20/12 - 21/12
FRAMING
Once the final location has been determined (observing
clearances for vent termination), you may construct framing
using dimensions shown in figures 10 through 12, depending
on the particular installation.
Figure 10
Figure 11
ft
mm
1
305
1.5
457
2
610
2.5
762
4
1219
5
1524
6
1829
7
2134
7.5
2286
8
2438
If the appliance is to be installed directly on carpeting, tile
(other than ceramic), or any combustible material other than
wood flooring, the appliance must be installed upon a metal or
wood panel extending the full width and depth of the fireplace.
Figure 12
ELECTRICAL HOOK-UP AND REMOTE RECEIVER
DIAGRAM
A wire way with two receptacles has been supplied for your
convenience and is located on the lower right hand side of the
appliance (see figure 13).
Figure 13
Due to high temperatures, make sure no wires are touching the
bottom of the firebox.
-6 -
WIRE WAY
For more information, visit www.desatech.com
Advertisement
Table of Contents
