Table of Contents
Advertisement
FOR YOUR SAFETY
•
Do not store or use gasoline or any other flammable
vapors or liquids in the vicinity of this or any other
appliance.
•
Due to high temperatures, the appliance should be
located out of traffic and away from furniture and
draperies.
•
Do not place clothing or other flammable materials on
or near the appliance.
•
NEVER leave children unattended when a fire is
burning in the fireplace.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire
department.
WARNING:
Improper
alteration, service or maintenance can cause injury,
property damage, or loss of life. Refer to this manual for
assistance or additional information. Consult a qualified
installer or local distributor.
CHECK LOCAL CODES BEFORE
INSTALLING THIS FIREPLACE.
INTRODUCTION
Model DVF32TMHPN is a heat circulating gravity direct vent
gas fireplace with sealed combustion chamber. This fireplace
uses a millivolt gas control valve and millivolt ignition
system.
This fireplace is convertible with the standard setup as natural
gas. Conversion may be performed by the O.E.M. mobile
home builder or by a qualified service person on-site. If you
are uncertain as to what gas your unit is equipped for, please
check the rating plate located in the interior of the appliance
opening or consult your mobile home supplier or your local
distributor of DESA/Coleman products.
BEFORE BEGINNING THE INSTALLATION OF THE
FIREPLACE, READ THESE INSTRUCTIONS THROUGH,
COMPLETELY.
♦ This DESA/Coleman fireplace and its components
are safe when installed according to this installation
manual. Unless you use DESA/Coleman components,
which has been designed and tested for the fireplace
system, you may cause a fire hazard.
♦ The DESA/Coleman warranty will be voided by and
DESA disclaims any responsibility for the following
actions:
installation,
adjustment,
a) Modification of the fireplace, components, doors,
blower, fans, air inlet system and damper control.
b) Use of any component part not manufactured or
approved by DESA/Coleman in combination with a
DESA/Coleman fireplace system.
PROPER INSTALLATION is the most important step in
ensuring safe and continuous operation of the fireplace.
Consult the local building codes as to the particular
requirements concerned with the installation of all factory
built fireplaces. This fireplace, when installed, must be
electrically grounded in accordance with local codes, or in
absence of local codes, with the National Electrical Code
ANSI/NFPA 70 and CSA C22.2 Canadian electrical code for
Canada.
The installation must conform to local codes, or in the absence
of local codes, with the national Fuel Gas Code ANSI Z223.1
– current installation code CAN/CGA-B149. This appliance
complies with ANS Z21.88-2000/CSA 2.22-2000 VENTED
GAS FIREPLACE HEATERS.
SELECTING LOCATION
To determine the safest and most efficient location for the
fireplace, you must take into consideration the following
guidelines:
The location must allow for proper clearances (see
figure 1).
Consider a location were the fireplace would not be
affected by drafts, air conditioning ducts, windows or
doors.
A location that avoids the cutting of joists or roof
rafters will make installation easier.
In selecting a location, the following precautions must be
observed:
Do not connect this appliance to a chimney system
used for solid fuel burning fireplace.
Due to high temperatures, do not locate this appliance
in high traffic areas or near furniture and draperies.
Never obstruct the front opening of the appliance or
the flow of combustion and ventilation air. Keep
control compartments accessible.
Do not locate close to where gasoline or other
flammable liquids may be stored. The appliance area
must be kept clear and free from these combustible
materials.
Do not use this appliance if any part has been under
water. Immediately contact a local service technician
to examine the fireplace and to replace any part of the
control ignition system and other related components
that has been submerged under water.
MINIMUM CLEARANCES TO COMBUSTIBLES
•
Back, side and top spacers ------------------
•
Floor ------------------------------------------
•
Perpendicular wall ---------------------------
•
Ceiling to opening ---------------------------
•
Sidewall (at nailing flange) ----------------
-2 -
For more information, visit www.desatech.com
0"
0"
2"
36"
0"
Advertisement
Table of Contents
