To Erase The Memory - Chamberlain 8065 Installation Manual

Operation
Remote Control
Your remote control has been programmed at the factory to operate with your
garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 40 for compatible
accessories. Programming can be done through the door control or the learn button the
garage door opener. To program additional accessories refer to the instructions provided
with the accessory or visit www.LiftMaster.com. If your vehicle is equipped with a
Homelink , you may require an external adapter depending on the make, model, and year
®
of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control:
Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has
been programmed. Repeat the steps above for programming additional remote controls
or keyless entry devices. If programming is unsuccessful, program the remote using the
learn button.
1
The command LED
will flash once.
3
2
The command LED will
flash once again.
OR
? ? ? ?
PIN
PROGRAM USING THE GARAGE DOOR OPENER
1. Locate the Learn button on the garage door opener.
2. Press and immediately release the Learn button. The Learn LED will glow steady
for 30 seconds. Within 30 seconds...
3. Press and hold the button the remote control that you wish to use. Release the
button when the garage door opener lights blink or two clicks are heard. If
programming to other products, press the button a second time to activate
products.
1-2
LEARN LED

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LED goes
out (approximately 6 seconds). All remote control and keyless entry codes are
now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
1. Press and hold the learn button on garage door opener until the learn LED goes
out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the learn LED goes out.
All codes are now erased.
Reprogram any accessory you wish to use.
35
3
LEARN
Button
enabled accessories)
®