Power Supply Module; Power Supply Backplane - HP ProLiant ML350p Gen8 Maintenance And Service Manual

Power supply module

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 27).
o
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Access the product rear panel.
4.
If removing a DC power supply, first remove the grounding wire.
5.
Remove the power supply.
6.
WARNING:
power supply blank to cool before touching it.
To replace the component, reverse the removal procedure.

Power supply backplane

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 27).
o
To prevent improper cooling and thermal damage, do not operate the server unless
To reduce the risk of personal injury from hot surfaces, allow the power supply or
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the tower bezel" on page 27).
("Remove the tower bezel" on page 27).
Removal and replacement procedures 41