Safety Check After Servicing - Denon DVD-910 Service Manual

QQ
3 7 63 1515 0

Safety Check after Servicing

Examine the area surrounding the repaired location for
damage or deterioration. Observe that screws, parts,
and wires have been returned to their original posi-
tions. Afterwards, do the following tests and confirm the
specified values to verify compliance with safety stan-
dards.
1. Clearance Distance
When replacing primary circuit components, confirm
specified clearance distance (d) and (d') between sol-
dered terminals, and between terminals and surround-
ing metallic parts. (See Fig. 1)
Table 1: Ratings for selected area
AC Line Voltage
120 V
Note: This table is unofficial and for reference only.
Be sure to confirm the precise values.
2. Leakage Current Test
Confirm the specified (or lower) leakage current
between B (earth ground, power cord plug prongs) and
externally exposed accessible parts (RF terminals,
antenna terminals, video and audio input and output
terminals, microphone jacks, earphone jacks, etc.) is
lower than or equal to the specified value in the table
TE
L 13942296513
below.
Measuring Method (Power ON) :
Insert load Z between B (earth ground, power cord plug
prongs) and exposed accessible parts. Use an AC volt-
meter to measure across the terminals of load Z. See
Fig. 2 and the following table.
Table 2: Leakage current ratings for selected areas
AC Line Voltage
120 V
Note: This table is unofficial and for reference only. Be sure to confirm the precise values.
www
.
http://www.xiaoyu163.com
Clearance Distance (d) (d')
≥
3.2mm (0.126 inches)
Load Z
0.15µF CAP. & 1.5kΩ RES.
Connected in parallel
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Chassis or Secondary Conductor
Primary Circuit Terminals
d'
Exposed Accessible Part
Z
1.5k
Q Q
0.15 F
3 6 7 1 3 1 5
Earth Ground
B
Power Cord Plug Prongs
Leakage Current (i)
i≤0.5mA Peak
co
.
6
DVD-910
9 4 2 8
d
Fig. 1
AC Voltmeter
(High Impedance)
0 5 8 2 9 9 4 2 8
Fig. 2
Earth Ground (B) to:
Exposed accessible parts
m
6
9 9
9 9