Safety Check After Servicing - Denon DVD-1710 Service Manual

QQ
3 7 63 1515 0

Safety Check after Servicing

Examine the area surrounding the repaired location for
damage or deterioration. Observe that screws, parts,
and wires have been returned to their original posi-
tions. Afterwards, do the following tests and confirm
the specified values to verify compliance with safety
standards.
1. Clearance Distance
When replacing primary circuit components, confirm
specified clearance distance (d) and (d') between sol-
dered terminals, and between terminals and surround-
ing metallic parts. (See Fig. 1)
Table 1: Ratings for selected area
AC Line Voltage
120 V
Note: This table is unofficial and for reference only.
Be sure to confirm the precise values.
2. Leakage Current Test
Confirm the specified (or lower) leakage current
between B (earth ground, power cord plug prongs)
and externally exposed accessible parts (RF termi-
nals, antenna terminals, video and audio input and
output terminals, microphone jacks, earphone jacks,
etc.) is lower than or equal to the specified value in the
TE
L 13942296513
table below.
Measuring Method (Power ON) :
Insert load Z between B (earth ground, power cord
plug prongs) and exposed accessible parts. Use an
AC voltmeter to measure across the terminals of load
Z. See Fig. 2 and the following table.
Table 2: Leakage current ratings for selected areas
AC Line Voltage
120 V
Note: This table is unofficial and for reference only. Be sure to confirm the precise values.
www
.
http://www.xiaoyu163.com
Clearance Distance (d), (d')
≥
3.2mm (0.126 inches)
Load Z
0.15µF CAP. & 1.5kΩ RES.
Connected in parallel
x ao
y
i
http://www.xiaoyu163.com
8
Z
1.5k
Q Q
3 6 7 1 3
B
Leakage Current (i)
i≤0.5mA Peak
u163
.
6
DVD-1710/555
2 9 9 4 2 8
Chassis or Secondary Conductor
Primary Circuit Terminals
d' d
Exposed Accessible Part
AC Voltmeter
(High Impedance)
0.15 F
1 5 0 5 8 2 9 9 4
Earth Ground
Power Cord Plug Prongs
Earth Ground (B) to:
Exposed accessible parts
m
co
9 9
Fig. 1
2 8 9 9
Fig. 2