Denon DVD-910 Service Manual page 9

QQ
3 7 63 1515 0
2. Installation
(1) Using desoldering braid, remove the solder from the
foil of each pin of the flat pack-IC on the CBA so you
can install a replacement flat pack-IC more easily.
(2) The "I" mark on the flat pack-IC indicates pin 1.
(See Fig. S-1-7.) Be sure this mark matches the 1
on the PCB when positioning for installation. Then
presolder the four corners of the flat pack-IC. (See
Fig. S-1-8.)
(3) Solder all pins of the flat pack-IC. Be sure that none
of the pins have solder bridges.
Example :
Pin 1 of the Flat Pack-IC
is indicated by a "
TE
L 13942296513
CBA
www
.
http://www.xiaoyu163.com
" mark.
Fig. S-1-7
Presolder
Flat Pack-IC
Fig. S-1-8
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Instructions for Handling
Semi-conductors
Electrostatic breakdown of the semi-conductors may
occur due to a potential difference caused by electro-
static charge during unpacking or repair work.
1. Ground for Human Body
Be sure to wear a grounding band (1MΩ) that is prop-
erly grounded to remove any static electricity that may
be charged on the body.
2. Ground for Workbench
(4) Be sure to place a conductive sheet or copper plate
with proper grounding (1MΩ) on the workbench or
other surface, where the semi-conductors are to be
placed. Because the static electricity charge on
clothing will not escape through the body grounding
band, be careful to avoid contacting semi-conduc-
tors with your clothing.
< Incorrect >
Q Q
3 6 7 1 3 1 5
< Correct >
1MΩ
co
.
9
DVD-910
9 4 2 8
0 5 8 2 9 9 4 2 8
CBA
Grounding Band
CBA
Conductive Sheet or
Copper Plate
m
9
9 9
9 9
1MΩ