Table of Contents
Advertisement
INSTALLATION
Attaching Mounting Bracket To
Wall
Note: Wall anchors, mounting
screws, and spacers are in
hardware package. The hardware
package is provided
Attaching to Wall Stud Method
For attaching mounting bracket to
wall studs
1. Drill holes at marked locations
"
using 9/64
drill bit.
2. Place mounting bracket onto
wall. Line up last hole on each
end of bracket with holes drilled
in wall.
3. Insert mounting screws through
bracket and into wall studs.
4. Tighten screws until mounting
bracket is firmly fastened to
wall studs.
Attaching to Wall Anchor Meth-
od
For attaching mounting bracket to
hollow walls (wall areas between
studs) or solid walls (concrete or
masonry)
1. Drill holes at marked locations
"
using 5/16
drill bit. For solid
walls (concrete or masonry),
"
drill at least 1
deep.
2. Fold wall anchor as shown in
Figure 8 below.
Figure 8 - Folding Anchor
3.
Insert wall anchor (wings
first) into hole. Tap anchor
flush to wall.
4.
For thin walls (1/2
insert red key into wall
anchor. Push red key to
"
"
pop
open anchor wings.
(see Figure 9).
Figure 9 - Popping Open Anchor
with heater.
Wing For Thin Walls
5. Place mounting bracket onto
wall. Line up last hole on
each end of bracket with wall
anchors.
6. Insert mounting screws through
bracket and into wall anchors.
7. Tighten screws until mounting
bracket is firmly fastened to
wall.
hammer
(over 1/2
do not pop open wings.
Placing Heater on Mounting
Bracket
1. Locate two horizontal slots on
back panel of heater (see
Figure 10).
2. Place heater onto mounting
bracket. Slide horizontal slots
onto
mounting bracket.
"
or less),
Figure 10 - Mounting Heater Onto
Mounting Bracket
IMPORTANT: Do not
key!
For thick walls
"
thick) or solid walls,
stand-out
tabs
on
8
Installing Bottom Mounting
Screws
1. Locate bottom mounting hole. This
hole is near bottom on back
panel of heater (see Figure 11).
2. Mark screw locations on
wall.
3. Remove heater
from mounting
bracket.
Figure 11 - Installing Bottom
Mouting Screw
4.
If installing
bottom mounting
screw into hollow or solid
wall, install wall anchors. Fol
low steps 1 through 4 under
Attaching to Wall Anchor
Method. If installing bottom
mounting screw into wall stud,
drill holes at marked locations
"
using 9/64
drill bit.
5. Replace heater onto mounting
bracket.
6. Place spacers between bot-
tom mounting holes and wall
anchor or drilled hole.
7. Hold spacer in place with one
hand. With other hand, insert
mounting screw through bottom
mounting hole and spacer. Place
tip of screw in opening of wall
anchor or drilled hole.
8. Tighten screw until heater is firmly
secured
to wall. Do not
over tighten.
Note: Do not replace lower front
panel at this time. Replace lower
front panel after making gas
connections and checking for
leaks (see page 9).
Advertisement
Table of Contents
