Wall Mounting Installation; Operation And Use - DeLonghi HCX Series Instructions For Use Manual

Electrical connection
- Before connecting the appliance to the current outlet,
check that the voltage indicated on the appliance rating
plate is the same as your electric plant and that it can stand
the power consumption (Watt) indicated by the labelling.
- If more than one appliance is used at once, it is important to
ensure that the electric plant is able to support the power
required.
Mounting the feet
Turn the appliance upside down on a rug or soft surface in order
to prevent damaging the paint finish.
Fix the feet to the appliance with the nr. 4 screws B supplied
(see fig. 1), 2 screws for each foot.
Wall-Mounting Installation
The wall mounting kit contains:
4 metal brackets (A)
2 screws 4.8x13 PH (B)
4 screws 4.5x25 PH (C)
4 plastic anchors 6x30 (D)
Required tools for assembly and estimated assembly
time
Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes
Before installing the unit , make sure of the following:
a. The appliance must not be located directly beneath
a current outlet.
b. The plug and outlet must be easy to reach after
installation.
c. No electric cables or other pipes could be damaged
during the installation.
d. Keep away from curtains or flammable materials.
To wall-mount, proceed as follows:
Turn the appliance upside down on a flat stable surface. Using
a screwdriver, fix the 2 brackets A with the 2 screws B as shown
in Fig. 2.
For brick walls use a 6 mm concrete drill bit. For plaster board
or false (hollow) walls, it is recommended to use appropriate
screws and anchors (not supplied).
1. Before drilling the wall, mark the exact points, respecting
the minimum distances as shown in fig. 3.
2. Drill the wall where previously marked, and insert the
plastic anchors D.
3. Fix the 2 metal brackets A using the two screws C provided.
4. Hang the appliance on the bracket.
5. Mark out the 2 lower fixing points. Remove the appliance,
drill the lower holes and insert the wall anchors D.
6. Now, you can hang back the heater on the bracket and
fix the lower part of the appliance with the 2 remaining
screws C.
USE

Operation and use

1. Plug into the mains socket.
2. The appliance emits a beep. The
comes on and remains lit while the appliance is powered.
3. The appliance switches to stand-by.
4. Press the ON/STAND-BY to turn the appliance on. It begins
heating the room according to the current settings.
5. Press the MODE button to select one of the following
operating modes:
Freeze prevention
Heating 1
Heating 2
Heating 3
Heating 3 + Fan
5.1 Freeze prevention
In this mode, the appliance keeps the room at a
temperature of 7°C to avoid freezing.
5.2 Heating 1, 2, 3 and Heating 3 + Fan
In this mode, the desired temperature can be selected
by pressing the adjustment buttons + and –. By
pushing the + or - button once, the temperature
(shown on the display) will increase or decrease by
1°C.
Heating 1
The appliance operates at low power.
Heating 2
The appliance operates at medium power.
Heating 3
The appliance operates at high power.
Heating 3 + Fan
The appliance operates at the maximum power with
the fan.
The setting temperature range available is from 16°C
to 32°C.
6. "ECO plus" function
The "ECO plus" function is available in Heating 1, 2 3 and 3 +
5
power indicator light